Before & After Photos

We responded to a call from Steve L. of Gig Harbor, Washington regarding a basement area that was continuously flooding with ground water seepage. Inspection showed water intrusion throughout with water entering around the perimeter slab/wall cold joint as well as water and silt being pushed though floor cracks by the hydrostatic pressure.  And yes, the before picture is standing water on the floor.

Customer was wanting to get their basement space back and usable for storage as well as protect mechanical systems from damage.

We recommended and installed a WaterGuard perimeter drainage system as well as followed the floor cracks using backless WaterGuard all tied to a SuperSump sump pump system with an UltraSump3 battery back up system to insure the basement stays dry even during a power outage.

After the waterproofing was completed we finished the basement using Basement to Beautiful insulated wall panels, EverLast finish wall panels, and ThermalDry Plank Flooring. 

Installing a Sump Pump in a Basement 

Install of a Pump and drainage in Shelton 

Installation of WaterGuard System and a SuperSump sump pump to de-water the footing-wall-slab joint along the back wall of the basement to collect ground water intrusion and remove from the below grade space.  Photos show water damage at wall and WaterGuard installed and concrete floor repaired.

Here at Clean Space Northwest, we specialize in Basements. Here is a before and after photos of a basement we finished in Seabeck Washington. 

Although we did this basement in Seabeck we also do jobs in areas all over the state. If you want to see where we service please click this link: