Before & After Photos

Crawl Space Moisture Problem and Standing Water Concerns

A homeowner in Tupelo, MS had standing water in the crawl space, concerns about mold, and wanted a long-term moisture control solution after moving into the home less than a week earlier. The crawl space covered roughly 1,000 square feet beneath part of the home and had unusually tall perimeter walls, with some areas reaching about 8 feet high. During the inspection, our team found that water was moving toward the back section of the crawl space, where an existing sump pump had already been tied into plumbing lines. The homeowner wanted better peace of mind, improved indoor air quality, and confidence that the crawl space would not create future moisture, mold, or structural problems.

Full Crawl Space Encapsulation and Drainage Solution

Redeemers Group completed a full crawl space encapsulation system, removed approximately 1,100 square feet of old roll insulation, and cleared debris that included an old vapor barrier, glass bottles, and broken brick. The crew installed CleanSpace vapor barrier throughout the crawl space, wrapped piers, covered the perimeter walls, and used SilverGlo insulation to help partition and seal openings near the front porch and rear porch areas. The existing sump pump was replaced and discharged out the back of the home with an additional 25 feet of discharge line. A second standalone sump pump was installed beneath the rear patio area, and the encapsulation around that pump was made removable so the system could still be accessed for service. Where standing water was found away from the sump location, the team trenched between the wet area and the sump to help direct water toward proper drainage.

Why Crawl Space Encapsulation, Sump Pumps, and Vapor Barriers Matter

This Tupelo crawl space repair showed why waterproofing, vapor barrier installation, insulation removal, and crawl space drainage should work together as one system. A vapor barrier helped separate the home from ground moisture, while encapsulation helped create a cleaner and more controlled crawl space environment. Replacing and adding sump pumps gave water a managed path out of the crawl space instead of allowing it to collect beneath the home. SilverGlo insulation helped improve the sealed system, especially around openings that could allow outside air and moisture to enter. During the final walkthrough, the homeowner was highly satisfied with the completed crawl space encapsulation and drainage improvements, which helped provide the quality of life and peace of mind they were looking for.

Call Redeemers Group for Crawl Space Encapsulation in Tupelo, MS

If you have standing water, musty odors, mold concerns, wet insulation, or need a crawl space vapor barrier in Tupelo, MS or the surrounding area, Redeemers Group can help. Schedule a crawl space inspection today to learn how encapsulation, drainage, sump pumps, and moisture control can help protect your home from future crawl space problems.

Regina had us out about a year ago because she had flooding into her basement from the outside. She had some landscaping redone and thought it had been addressed with proper drainage, but water still got into her basement. At the time of the appointment a year ago the basement was finished and she did not like the idea of having to remove floors that she had just put down and redoing sheet rock. However, she just had some pipes burst with the recent snowstorm and it leaked from the upper floor down into the finished basement and caused lots of damage. When the flooring got pulled up, she noticed that the basement was leaking and knew it was time to get the waterproofing done.

Check out this project we did for Sarah C. of Hot Springs National Park, AR.  Here joists were sagging due to moisture.  We used our SmartJacks® crawl space support jacks to lift and stabilize the structure. For added protection, we applied LumberKote® Wood Sealant to all the wood under the home.  Sarah can rest assured that moisture will no longer pose a threat to the stability of her home.

Foundation Settlement and Structural Instability Threatened Home Integrity

Significant foundation settlement and inadequate structural support caused visible drywall cracking and ongoing floor instability, requiring a comprehensive stabilization and waterproofing solution to prevent further damage.

Over the course of a year, the homeowner in Mountain Home, AR began noticing cracks forming in the drywall—clear signs of foundation settlement and structural movement. The home’s design relied on a single center fly-over steel beam, leaving large sections of flooring and load-bearing walls unsupported. This lack of proper support led to sagging floor joists, uneven load distribution, and increasing concern as the homeowner prepared for future renovations. A crawlspace and basement combination further complicated the issue, requiring a customized approach to avoid obstructing key access points like the basement doorway and storage areas.

SmartJack System, Push Piers, and Custom Beam Installation Delivered Lasting Stability

To address the structural issues, a tailored solution was implemented using a combination of SmartJack support systems, supplemental beams, joist sistering, and foundation push piers. A 30-foot supplemental beam was installed along both the front and rear of the home, supported by strategically placed SmartJacks—six in the front to address heavier load demands and four in the rear. Joist sistering reinforced weakened spans, particularly under high-traffic areas like the bathroom, while adjustments were made near the storage room to preserve accessibility without compromising structural integrity.

Additionally, eight push piers were installed along the southeast corner to permanently stabilize the settling foundation—five from inside the crawlspace and three requiring exterior concrete removal and replacement. The team overcame challenging excavation conditions, including large subsurface stone, and adapted installation methods where necessary. Minor customizations, such as shimming select joists to reduce floor noise, were completed at the homeowner’s request while maintaining transparency about best practices.

Integrated Waterproofing and Encapsulation Enhanced Long-Term Protection

Beyond structural stabilization, the project incorporated advanced waterproofing and encapsulation strategies to protect the home from future moisture-related damage. A CleanSpace vapor barrier system was installed throughout the crawlspace and basement walls, seamlessly integrated with a Dry-Trak drainage system to channel water into a new sump pump system. The discharge line was upgraded with a Spee-D drain to redirect water away from the driveway, improving both function and curb appeal.

This integrated approach ensured not only immediate structural correction but also long-term durability by addressing underlying moisture concerns—a critical factor in preventing future foundation issues. The combination of engineered support systems, customized installation methods, and moisture control solutions provided a comprehensive repair that restored stability and peace of mind for the homeowner.

Schedule Your Foundation Inspection Today

If you’re noticing cracks in your drywall, uneven floors, or signs of foundation settlement, don’t wait for the problem to worsen. Contact our team today to schedule a professional inspection and discover customized solutions designed to protect your home for years to come. 

Identifying Serious Crawlspace Settlement and Structural Risks

This project involved a home in Mountain Home, AR where the crawlspace had been settling for years, creating structural concerns that affected floors, doors, and interior walls. The homeowner, Jay B., a veteran dealing with health challenges, had previously attempted repairs himself and had even received a quote from another company. However, the settling continued, causing cracks in multiple rooms and making it harder for him to ensure his wife would have a safe, reliable home to live in or eventually sell. After our inspection, Jay sought a permanent, trustworthy solution that stayed within his budget while still restoring the home’s stability.

Delivering a Targeted SmartJack Solution for Long-Term Stability

We provided a tailored repair plan that focused on the most affected support areas while respecting the homeowner’s financial considerations. By installing a series of SmartJacks along the main beam, we delivered a powerful and lasting lift, even within the constraints of a gravel crawlspace and limited access points. Despite HVAC and plumbing obstacles, our installation team successfully maneuvered through the tight entry and low-clearance areas to position the system correctly. This approach offered far better long-term performance than the competing option Jay had previously been offered, giving him the peace of mind of a dependable structural repair.

Restoring Interior Functionality Through Proven Structural Methods

The effectiveness of the SmartJack system became immediately clear. The installation closed cracks in the full bathroom near the door and ceiling, restored the functionality of a sticking door, and eliminated cracks on both sides of the half bath—including the wall facing the laundry room and the front interior area. These visible improvements underscored the importance of using engineered support systems designed specifically for crawlspace settlement. By applying methods that directly address the root cause, we delivered stability, safety, and long-term value to the home.

Ensure Your Home Stays Safe and Structurally Sound
If you’ve noticed sagging floors, sticking doors, or interior cracking, now is the time to secure a permanent solution. Contact Redeemers Group today for a professional inspection and a repair plan designed to protect your home—and your peace of mind.