Before & After Photos

Kyle had 2 slabs of concrete in the driveway and then 1 slab in the sidewalk that sank. We used PolyLevel to lift up the fallen concrete and make sure there were no hazards due to the unevenness. PolyLevel is an injected foam that raises the concrete from below and is waterproof so that it won't get washed away.  

Will's driveway was sinking and during the rain, water would pool in the middle. We used PolyLevel for their solution. PolyLevel is an injectable foam what lifts concrete and is waterproof so the rain won't wash it away. The foam cures in only 15 minutes so that the driveway can be full load bearing in just a short time!

The sinking stairs made the front of this home unattractive and created a tripping hazard for those walking up. This problem was resolved in less than two hours thanks to PolyLEVEL. With a special mixture of polymers, the concrete step was raised with minimal mess and was able to be walked on in 15 minutes!

Once the snow melted, Bill realized his steps had sunk about 2", making them uneven and unsafe. Luckily our PolyLEVEL injection system is the perfect solution to raise sinking concrete slabs such as steps. It was a one day job and the steps are as good as new!

This customer had a front porch slab that was sinking. The homeowner was looking for a solution that would permanently raise the slab and prevent it from settling again in the future.

The effective PolyLevel system was installed to raise the slab while dealing with the weak soils below that caused it sink in the first place. We drilled a few small holes into the concrete slab, deep enough to reach the soil below. We then injected specialized polymers underneath the concrete that expanded to immediately raise the slabs back to their proper levels. Once installed, the system only needed about 15 minutes to cure and the homeowner was left with the leveled porch he was looking for.