Before & After Photos

The renovators for this newly purchased home knew that the epoxy sealant applied to the foundation walls was not going to help this basement stay dry. You see, epoxy sealants and other sealants of the same nature don't fix the root cause of basement leaking issues. The real problem is all the water pressure sitting on the outside of the foundation walls, and the best way to relieve that pressure is an interior perimeter waterproofing system. We installed our system equipped with subfloor drains, a sump pump, and a vapor barrier. This system invites the built up water through weeping holes near the bottom of the foundation, (as seen in the before photo) and discharges all the water far away from the base of the home. After the system was installed, the renovators were ready to finish the basement however they like. 

This basement had an existing waterproofing system that eventually failed. We decided to replace their outdated system with our state-of-the-art interior perimeter system. The system we designed for this basement included our WaterGuard subfloor drainage system, our SuperSump sump pump system, and our BrightWall wall paneling system. The WaterGuard was installed all around the entire perimeter of the basement, ensuring all possible entrances for water leaks are directed to the sump pump. Our SuperSump is able to discharge 2,280 gallons of water per hour. Our BrightWall panels cover all the stained walls and help channel leaks from the walls down into the subfloor drains. The result of this project is a clean, dry, beautiful basement.

We installed a SuperSump Plus in this Winchester, KY, home to ensure water stays away from their foundation. The black battery seen next to the sump pump will turn on in case power outage ensues.

We waterproofed this basement in Winchester, Kentucky, by using our patented WaterGuard subfloor drains. The basement was attached to the garage and sat a couple feet deeper than the garage, so it received all the floods. We wrapped the basement with our interior perimeter drains and directed them to a sump pump (unpictured) to help manage water intrusions. We also installed a grated trench drain at the base of the garage door to help capture any water that may run in from the garage floor. The result is a dry basement where the homeowner won't have to worry about it flooding any longer.

This basement had some mold stains and wet spots that showed up every time it rained. In order to stop the moisture problem, we installed a full perimeter interior waterproofing system, as well as a full CleanSpace moisture barrier installation.